Electrical Connections - Eco-Smart ECO MINI 1 Installation And Operating Instruction

ELECTRICAL CONNECTIONS

To be certain that all of the air is out of the water heater, open the HOT
water faucet on your fixtures until constant water flows from them. If air
remains in the tank, the element will be damaged when connected to power.
Connect the water heater to a GROUNDED POWER SUPPLY.
The water heater is fitted with an electrical connection that is
intended to connect to a grounded 110-120 V/AC supply. Adhere to
all pertinent State and local codes. Install the correct size circuit
breaker into the master panel. The Ecosmart Mini Tank water heater
was manufactured and wired in accordance with UL requirements.
The water heater is equipped with an overheat-limiting device with a
manual reset. Also known as the temperature high limit, this device
has been factory installed to interrupt the power supply in the event
of a thermostat failure.
This water heater is designed for ONLY 110-120V electrical
service!!!!! DO NOT CONNECT TO HIGHER OR LOWER VOLTAGE.
Failure to use proper voltage may result in personal injury and/or property
damage. If the supplied electrical connection is either damaged or not long
enough, do NOT use an extension cord. Have a licensed electrician replace
.
the power cord
55
Page 12 of