The Clean Function - BALAY 3HF518B Instructions For Use Manual

The Clean function

How to program
Cancelling the function
22
3.
Hold the glass panels on the left and right and slide
them upwards. (Fig. B)
Lay it on a cloth with the handle underneath.
The inner glass panel with the hanging hook
remains on the oven carriage.
Clean the glass panels with glass cleaner and a soft
cloth.
4.
Insert the panels into the mounting on the oven
carriage again.
5.
Replace the cover and screw it back on. If the
cover cannot be screwed on, check whether the
panel is seated correctly in the mounting.
6.
Close the oven carriage again.
The oven must not be used again until the panels
have been correctly installed.
The Clean function is a regeneration program. If the
oven's catalytic walls have not cleaned themselves
sufficiently, this function may be used to regenerate
them. They will then be completely effective again.
Take all accessories and containers out of the oven.
Select the heating type 3 using the function control
knob.
Use the temperature control knob to set the
temperature level to 270 ºC Press the ! button. The
symbol will light up in the indicator panel. The Clean
function has been activated.
The oven will operate for an hour. When this time has
elapsed there will be an audible signal and the CL
symbol will flash in the indicator panel. Set the
function control knob and the temperature control
knob to 0. The Clean function will have been
deactivated.
If you want to deactivate the Clean function, press the
! button again. The CL symbol will disappear from
the indicator panel and the Clean function will have
been deactivated.