Hot Water (Optional); Hot Water Detection (Optional); Energy Saving - Bosch WAQ283S1GB Repair Instruction

5.10

Hot water (optional)

Washing programs under 40ºC:
The washing machine uses just cold water for the program.
Washing programs over 40ºC:
The first 3 litres of water are introduced through the cold water valve.
After that, it is connected the hot water valve.
If the hot water that flows in the appliance is colder as the program
temperature, the Heather is switched on.
If the hot water that flows in the appliance is hotter that the program
temperature, the hot water valve is switched off and the cold water will
be switched on to mix water.
5.11

Hot water detection (optional)

The washing machine checks at the beginning of every washing
program if the appliance is installed with a hot water supply.
The water flows though the hot water valve is detected by the flow
sensor and by the pressure increase detected by the pressure sensor.
The first time that the appliance detects that there is no hot water,
shows the message A:10 in the display. In the following washing
programs, if there is still not hot water, the module assumes that the
appliance is not connected to a hot water supply and does not show
the message again.
209_58300000178575_ARA_EN_C.doc – 30.06.2015
5.12

Energy saving

To reduce the energy consumption of the washing machine, the
display panel Lightning goes out a few minutes after the washing
program has finished. The start/Reload button flashes.
Press any button, turn the program selector or open the door to switch
on the lightning.
Page 28 de 70