7. Troubleshooting
7-1-4 Sheets are folded correctly, but staples are skewed.
(Cause)
Staple unit is skewed against sheets.
Transporting Direction of Sheets
(Remedy)
Adjust staple positions by moving staple unit
base.
Folding Line
NOTE
Staples
- When the positions of staples and folding line
is as shown in the above drawing, move the
rear side of the staple base to the right or move
the front side of the staple base to the left.
- When the positions of staples and folding line
is opposite from the positions as shown in the
above drawing, move the rear side of the staple
base to the right or move the front side of the
staple base to the left.
1. Insert pin into pin hole (F) at the front side.
Shaft (No.5) can be used instead of pin.
2. Loosen four M5-15 bolts.
3. Adjust staple base referring to NOTE above.
4. Fasten hour bolts.
5. Pull out pins.
Bolts M5-15
16
Rear Side
Joint Plate R
Bolts M5-15
Staple Unit
Front Side
Joint Plate F
Top View from Operation Panel
Pin Hole (R)
Staple Base
Pin Hole (F)