Advertisement
4. PREPARATION
4.1.
Battery Charging
4.1.1. The battery charge level may be checked at any time by pressing the red button adjacent to the charge indicator (fig.4). The level is
displayed by means of a clock face indicator. Full charge is indicated by a ¾ circle.
4.1.2. To release the battery from the riveter, press both battery latches together and slide the battery out (fig.2).
4.1.3. Slide the battery into the charger (fig.3) until the catches lock in place.
4.1.4. Plug the charger in to the mains supply.
4.1.5. Charger Indications:
4.1.6. To replace the battery in the riveter: slide back into the handle until the catches click
4.1.7. Recharge the battery pack when necessary and after each use.
4.1.8. If the riveter is not used for a considerable period, recharge the battery pack every six months.
4.2.
Nose Piece Selection:
4.2.1.
The correct nosepiece must be installed in the frame head for the size of rivet being used.
4.2.2.
To remove the nose piece, turn anticlockwise using the supplied spanner (fig.5).
4.2.3.
Replace with the appropriate nosepiece for the rivet being used.
4.2.4.
Use of an incorrect nosepiece will result in the rivet stem failing to release.
5. OPERATION
fig.5
5.1.
To insert rivets, place rivet in the pre-drilled hole (fig.6).
5.1.1.
Insert the rivet stem as far as possible into the riveter nosepiece (fig.7).
5.1.2.
Pull the trigger to pull the rivet up. Keep the trigger depressed until the rivet stem is heard to snap away from the head (fig.8).
5.1.3.
At this point, release the trigger; the machine will reverse automatically and release the stem.
6. MAINTENANCE
fig.9
6.1.
The head assembly will need to be stripped from time to time to clean and lubricate.
6.1.1.
Before any maintenance, remove the battery to avoid accidental starting.
6.1.2.
Remove the frame head by turning anticlockwise with the spanner (fig.9). This will reveal the jaw case head.
6.1.3.
To remove the jaw case head, turn anticlockwise using the spanner.
6.1.4.
This, in turn, will reveal the jaws, jaw pusher and spring (fig.10).).
6.1.5.
Clean with a suitable cleaner and, when dry, apply a little oil to the rear surfaces of the jaws.
6.1.6.
Assemble in the reverse order as 6.1.1. to 6.1.4.
6.1.7.
Clean the casing with a dry cloth only, do not use chemical cleaners.
6.1.8.
Store in a cool, dry place out of reach of children.
© Jack Sealey Limited
fig.6
fig.6
fig.10
Original Language Version
fig.7
fig.7
fig.8
CP313
Issue: 1 - 24/12/15
Advertisement
