Standard Disassembly Drawings - Samsung WA5471AB Series Service Manual

3-2. STANDARD DISASSEMBLY DRAWINGS

► This is a standard disassembly diagram and may differ from the actual product.
Use this material as a reference when disassembling and reassembling the product.
Part
Sub and Main PCB
Assembly
10 _ Disassembly and Reassembly
Hudson Washer.indb 10
Figure
1. Remove the 6 screws holding the control
2. Separate the both hooks. (Left and Right)
3. Separate the cover panel upward.
4. Remove the 2 screws holding the control
5. Pull the Encoder-Knob to separate it and
6. Separate the cover pcb(m) and the wires
Description
panel assembly.
If it is difficult to disassemble, use the (-)
driver to disassemble hooks.
(Be careful damage of hooks.)
panel assembly and turn the panel over.
then remove the 4 fixing screws.
When reassembling the PCB, take care
that you do not damage the control-panel
fixing hook. After replacing the sub PCB,
check the key operation.
connected to the main PBA.
After reassembling the housing, check
if the wires are properly connected.
When disassembling and reassembling
the housing, take care that you do not
damage the part.
2012-03-28 9:45:51