Taking A Breath Test - Monitech Interlock Systems QuicTest QT-1 Operator's Manual

Monitech Interlock Systems
Recall – A requirement to bring your vehicle back to your Interlock Provider's Service Center
within a limited number of days for servicing of the unit. This is generated by a pending Monitor
Appointment, a program violation, unit malfunction, or suspected tampering or abuse of the unit.
Redundant Alcohol Sensor – In the event that the Primary Alcohol Sensor in the unit
malfunctions, a Secondary Alcohol Sensor may be used (depending on the requirements of your
State Agency). This will allow vehicle operation for a limited number of days, until you can reach
your Service Provider's Service Center for repair. This sensor may be sensitive to substances
other than Alcohol, so it is very important that you ensure that you have not been eating,
smoking or drinking ANYTHING (other than water) for at least 5 minutes prior to any Breath
Test. Failure to do so may result in Temporary Lockout until your mouth is clear of all residues.
Running Test – A Breath Test required at random time intervals while the vehicle is being
driven. This can be taken as you drive, or you may pull off the road in a safe place and take it
while the engine is running.
Service Mode – This allows your vehicle to be serviced by a certified mechanic when your
vehicle requires automotive (not Interlock) service. It provides the mechanic with a means to
diagnose and operate the vehicle for a very limited amount of time without having to un-install
the device, or take a Breath Test. It requires a phone call from the mechanic to your Service
Provider.
Siren – This is the Alarm Siren that was included in your Interlock System installation.
Stall Protection – A 2 minute period of time after the engine is turned off for any reason
(including engine stall). It allows an immediate restart without the need to take a Start Test, to
ensure the driver is able to quickly move from an unsafe location (i.e. railroad tracks, a busy
intersection, etc) in the event of an engine stall.
Start Test – The Breath Test taken to allow you to start your vehicle.
Temporary Lockout – A short period of time, typically 5 or 30 minutes, when vehicle Start is
not permitted. This occurs after a failed Start Test. The first failure will normally result in a 5
minute lockout. If the next test is also a failure, the next lockout, and any following, will be for 30
minutes.
Visual Alert Device (VAD) – This is a small flashing light that can be installed (as an option) on
the vehicle dashboard for hearing impaired users. This will alert the user (who may not hear the
audible prompts and messages) that new information (text) is being displayed on the unit's LCD
that requires their attention when they can safely do so.
Warn – A Breath Test result equal to or greater than the Warn Level set by your State Agency,
but below the Fail Level.
Warning – Any caution message the device issues due to a user error or upcoming violation.
These include the detection of a level of Breath Alcohol below your set Fail Level, accidentally
trying to start your vehicle before taking a test, driving your vehicle close to a restricted drive
time (if applicable) and a variety of other events.
Section 5 Taking a Breath Test with QuicTest
The following instructions apply for any of the required tests; START, RUNNING, ENGINE OFF,
ARRIVAL, or BAC.
1. Before taking a Breath Test, make sure that your mouth is completely empty, and has had
nothing other than water in it for at least the last 5 minutes. If needed, rinse your mouth with
water to remove any other substances. Taking a Breath Test with food, beverage or smoke
residue may impact the results or damage the unit, and possibly delay starting your vehicle,
Page 8 of 17
QuicTest User Manual Rev A 2-16-08