Selection VG-2 modes
VG-2 mode is pre-set to on. To turn off VG-2, hold down
MUTE until the voice alert says, "VG-2 Off" and "VG2-
OFF" appears on the display.
To turn VG-2 on, hold down MUTE until the voice alert
says, "VG-2 On" and "VG2-ON" appears on the display.
RECEIVING AND IDENTIFYING
RADAR, LASER, AND SAFETY ALERT
SIGNALS
When your detector senses a radar signals, X, K, or KA
( Newly included Ka-POP
type of band detected sounds, and the display shows the
signal strength in numeric form.
X
K
K
A
Note: The closer you get to the source of the radar, the
higher the signal strength number increases.
20
)appears. An alert tone for the
9
9
9