Muting The Audio Alert; Selecting Vg-2 Mode; Receiving And Identifying Radar, Laser, And Safety Alert Signals - Radio Shack 360° Laser Radar Detector Owner's Manual

Muting the Audio Alert

When the detector sounds a radar or safety alert signal, press
to temporarily silence the detector. When you press
MUTE
, appears. The detector resets to go off 20 sec-
M
MUTE MUTE
onds after the signal stops. Or, press again before it re-
MUTE
sets, and M disappears. The laser alert signal remains audible
even if you press .
MUTE

Selecting VG-2 Mode

VG-2 mode is preset to off. To turn on VG-2, hold down
MUTE
until VG2-ON appears. To turn VG-2 off, hold down until
MUTE
appears.
VG2-OFF
Note: If there is another detector nearby, you might receive
false signals. To avoid receiving such signals, turn VG-2 off.
RECEIVING AND IDENTIFYING RADAR,
LASER, AND SAFETY ALERT SIGNALS
When your detector senses a radar signal, , , or appears.
X K KA
An alert tone for the type of band detected sounds, and the dis-
play shows the signal strength in numeric form.
Note: The closer you get to the source of the radar, the higher
the signal strength number.
When your detector senses an instant-on signal,
INSTANT -
ON appears and the instant-on alert tone sounds.
When your detector senses a laser signal, LASER flashes and
the laser alert tone sounds.
15
Operation