TIMETRAX™ SYNC RF ETHERNET TRANSMITTER
Installation Instructions 9T1WI, S9DWXSLAUB
OVERVIEW
Thank you for choosing a TimeTrax™ Sync RF Wireless Clock System. The TimeTrax™ RF Wireless Clock System
receives dependable, accurate time from the TimeTrax™ Sync RF Wireless Transmitter.
TimeTrax™ Sync Wireless RF Transmitters capture main time source from Network Time Protocol (NTP) server or GPS
to ensure a reliable time signal with no FCC license required. The transmitters use dependable frequency-hopping
technology to continuously broadcast a time signal to an unlimited number of TimeTrax™ Sync RF Wireless analog or
digital wall clocks with no interference.
additional signal coverage is required, an unlimited number of secondary transmitters may be added (part #
S9DSXOLAUB or 42337 sold separately).
The transmitters may also be used to transmit synchronization signals from a designated time source to TimeTrax™
Sync Bell/Tone System or TimeTrax™ Time Clock terminals.
For more information, visit pyramidtimesystems.com or call our technical support team at 888.479.7264 during
regular business hours: 8am-5pm EST, M-F.
1
Dependent upon facility construction & contents.
ANTENNA INSTALLATION
Remove contents from box and attach supplied antenna to top of transmitter by rotating in clockwise
direction.
IMPORTANT: Using anything other than included Power Supply or included Antenna in a vertical
orientation may be unsafe, cause improper operation, and violates FCC regulations.
ETHERNET
I2256
Page 1 of 5
888.479.7264
pyramidtimesystem.com
1
Each transmitter supports up to 250,000 sq. ft. of signal coverage. If