Bell Connection - Pyramid TIMETRAX SYNC 7000 User Manual

TIMETRAX™ SYNC 7000/7000BDL110 MASTER CONTROL
Installation Instructions
BELL CONNECTION & SCHEDULE
DC BeLL COnneCTiOn
The 7000 will provide power to 24V DC bells or horns, up to 800 milliamps (mA) per event.
1
Wire 24V DC Bells or Horns to the 7000
terminal labeled 24 VDC using 16-18
gauge wire (part #41449 sold separately)
Route the bell wire through the
2
cable channel located on right side
or bottom of 7000 case. A total of 35
bells or 20 Horns can be connected
to the circuit if using Pyramid bells
(part #41361, 41392) and horns (part
#41362).
Use the following table to set a bell/
3
horn schedule. Program up to 300
bell/horn events.
AC BeLL COnneCTiOn
CAUTION: 110V BELL RELAY MUST BE INSTALLED
BY A LICENSED ELECTRICIAN. Please refer to diagram.
7000
SELECT
SET-UP INSTRUCTIONS
To change or set feature,
1 3 After displayed feature is
press SELECT until desired changed, press SELECT to
feature is displayed. 24 VDC change other feature &
+ -
return to main display.
Use or to change
2
feature.
DATA POWER
11

BELL CONNECTION

pyramidtimesystem.com
2
2
To change or set feature,
1
press SELECT until desired
feature is displayed.
Use or to change
2
feature.
DATA
LOAD
NO
COM
NC
110V
Relay
ON
0 115 230
Ø 24
SELECT
SET-UP INSTRUCTIONS
After displayed feature is
3
changed, press SELECT to
24 VDC change other feature &
+ -
return to main display.
POWER
pyramidtimesystem.com
1
1
2
RED (+) BLACK (-)
POWER IN 110V AC
Line = Black
Neutral = Red or White
888.479.7264
LINE
NEUTRAL