Makita DGA404 Instruction Manual page 12

Cordless angle grinder
Hide thumbs Also See for DGA404:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Operation with abrasive cut-off /
diamond wheel (optional accessory)
Fig.20
Remove the battery cartridge from the tool and place it
upside down allowing easy access to spindle. Mount the
inner flange and abrasive cut-off / diamond wheel onto
the spindle. Tighten the lock nut securely with supplied
wrench. The direction for mounting the lock nut and the
inner flange varies by wheel thickness.
Refer to the table below.
100 mm (4")
Abrasive cut-off wheel
Thickness: Less than 4 mm (5/32")
16 mm (5/8")
1.
Lock nut
115 mm (4 - 1/2") / 125 mm (5")
Abrasive cut-off wheel
Thickness: Less than 4 mm (5/32")
22.23 mm (7/8")
1. Lock nut
010848
WARNING:
When using an abrasive cut-off / diamond wheel, be
sure to use only the special wheel guard designed for
use with cut-off wheels. (In some European countries,
when using a diamond wheel, the ordinary guard can be
used. Follow the regulations in your country.)
NEVER use cut-off wheel for side grinding.
Do not "jam" the wheel or apply excessive
pressure. Do not attempt to make an excessive
depth of cut. Overstressing the wheel increases
the loading and susceptibility to twisting or binding
Thickness: 4 mm (5/32") or more
1
2
16 mm (5/8")
3
2.
Abrasive cut-off wheel
Thickness: 4 mm (5/32") or more
1
2
22.23 mm (7/8")
3
2.
Abrasive cut-off wheel
Diamond wheel
Thickness: Less than 4 mm (5/32")
20 mm (13/16")
3.
Inner flange
4.
Diamond wheel
Thickness: Less than 4 mm (5/32")
22.23 mm (7/8")
3.
Inner flange
4.
of the wheel in the cut and the possibility of
kickback, wheel breakage and overheating of the
motor may occur.
Do not start the cutting operation in the workpiece.
Let the wheel reach full speed and carefully enter into
the cut moving the tool forward over the workpiece
surface. The wheel may bind, walk up or kickback if
the power tool is started in the workpiece.
During cutting operations, never change the angle
of the wheel. Placing side pressure on the cut-off
wheel (as in grinding) will cause the wheel to crack
and break, causing serious personal injury.
A diamond wheel shall be operated perpendicular
to the material being cut.
12
Thickness: 4 mm (5/32") or more
1
4
20 mm (13/16")
3
Diamond wheel
Thickness: 4 mm (5/32") or more
1
4
22.23 mm (7/8")
3
Diamond wheel

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dga454Dga504

Table of Contents