Table of Contents
Advertisement
Installation Process (Cont.)
6 . Place the unit through the hole and shift it
up to cover any exposed hole .
7 .
Mark the screw locations in the corners of
the cover and remove the unit .
8 . Drill the holes out and place the four (4)
Threaded Bolts through the holes, from the
inside, protruding out .
9 . Place the four (4) Hex Nuts on the bolt and
tighten with the aid of a wrench .
10 . Place the unit through the hole and thread
the remaining four (4) Wing Nuts onto the
Threaded Bolts, making sure a seal is created
along the backside of the Ballast Housing .
11 . Plug your unit into the outlet .
7
Advertisement
Table of Contents
