Advertisement
Fig.13
In case you change the return spring as
weil,
undo
the
screws,
that
retains
the plastic
cassette,
which the n can be removed.
Change the spring
and
lubricate it
with
engine oil.
Assemble the remaining parts in reverse order of
removal.
lift
up the starter cord into the notch on the pulley.
Tension
the
return spring by turning the pulley clockwise about two
tums.
NOTE!
Make
sure,
that
il
is possible to tum the pulley
at
JeasthaJt
a
tum
further
when the cord is fully pulled
out.
\
STARTING THE CHAIN SA W
A.
Cold
engine
Fig.14
1.
Switch on
the
ignition (push the
stop
switch to the right so
that
the
1
is visible).
2.
Pull
out the
choke
controI.
Fig.15
3.
Push
down the throttle
safety
catch
(A).
4.
Open
the throttle fully (B).
5.
Push the starting throttle ratehet backwards
(C).
Now
all controis
are in starting position and the chain
saw
is
ready to be starred.
6.
Put your right foot on
the plate
beneath
the
rear hand
le.
7. Grasp the front
handle
with your left hand and press
the saw
against the
ground.
8.
Grasp the starter handle with your right hand and pull
out the
starting cord slowly until the starter pawls
engage.
9.
Give the starting cord a short
sharp tug.
NOTE!
Do not pull
the starting cord entirely out or
release
the
starting
handle in pulled out
position,
as
this can
cause damages
on the
chain
saw.
10.
Normally the
engine
will
start after 2-3
starting
atternpts.
Push the choke
controi
as
soon the engine
starts.
Open rapidly the throttle wide and the
catch
will
disengage.
B.
Warm engine
Use the same starting
procedure
as for cord
engine but without
pulling out the choke
controI.
Fig.16
NOTE!
One
of the most
common eauses
of starting
difficulties
is,
that
too
many
starting
attempts
have
been
made
with
a
closed choke
flap.
If
this
is
the
case,
remove the sparking
plug and wipe it dry.
Open
the choke
flap
fully.
Before your
reassemble
the
sparking
plug,
we
recommend you to
pull
the starting handle several times
to "ventilate
the
cylinder",
the
stop switch in
O-position.
Assemble
the sparking plug and make a new starting attempt with
open choke flap and full
throttle.
CAUTION!
GUIDE BAR, CHAIN AND CLUTCH COVER
MUST
BE
MOUNTED BEFORE THE ENGINE IS STARTED, OTHER-
WISE
THE CLUTCH MAY COME LOOSE AND
CAUSE IN-
Advertisement
