Table of Contents
Advertisement
CP Drill
Restarting a warm machine
1. Check that the choke is open (in position WORK).
2. Pull the starter handle.
3. If the machine still does not start follow the
procedure for "Cold start and warm-up" or see
the section "Troubleshooting".
Stopping
1. Stop the machine by sliding the stop button on
the left handle forward.
9800 1669 01 | Original instructions
Safety and operating instructions
Operating
Starting a cut
Stand in a stable position with your feet well away
♦
from the working tool.
♦
Press the machine against the working surface
before starting. The feed force should be adjusted
so that the handles are pressed about half way
down (A) level with the ground during operation.
This position provides the best vibration damping
and the best breaking force.
A
The working speed of the machine is controlled
♦
via the throttle lever.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without leverage.
Never break off too large pieces. Adjust the
♦
breaking distance (A) so that the working tool
does not fasten.
Breaking
Never use the machine as a lever, the material
♦
should be broken by impact energy.
Let the machine do the work. Never press too
♦
hard. The vibration absorbing handle should never
be forced all the way to the bottom.
Release the throttle lever when the machine is
♦
lifted.
A
17
Advertisement
Table of Contents
