Advertisement
Available languages
Available languages
HANDLING AND STORING THE OIL
Make sure all oil is only handled when it is completely cool!
• Remove any food residues from the oil after use.
• Filter the oil regularly.
• The oil should be changed once it has been used approximately 10 times. All the oil should be
changed at the same time; do not mix old and new oil. The old oil should be disposed of as per the
relevant local regulations.
• Keep the oil in the deep fat fryer or in an airtight container in a dry, cool and dark place. (It is not
necessary to keep the oil in a fridge).
CLEANING
• The heating element with control panel and cord must not be immersed in water. Remove the
control panel and heating element before cleaning the appliance.
• Once you have poured the oil out of the bowl, wipe the inside of the bowl with kitchen paper.
Then wash the bowl thoroughly.
• The husing, bowl, lid and basket with handle can be washed in hot water and washing-up liquid or
in a dishwasher.
• Do not use any kind of strong or abrasive cleaning agent on the deep fat dryer or its accessories.
Never use a steel brush or scrubbing brush to clean the appliance, as this may damage the surface.
STORAGE
• Wait until the appliance is completely cool before putting it away.
• The bowl is best stored with a little oil in it. If you do this, you should check that the lid is closed
properly so that no dust or dirt can get into the oil.
FOR UNITED KINGDOM ONLY
Plug wiring:
This product is fitted with a BS 1363 13-amp plug. If you have to replace the fuse, only those that
are ASTA or BSI approved to BS1362 and with a rated current of 13 amps should be used. If there is
a fuse cover fitted, this cover must be refitted after changing the fuse. If the fuse cover is lost or
damaged, the plug must not be used. You must also check if the socket outlets in your home fit with
the plug of the appliance. If the socket outlet in your home does not fit with the plug, the plug must
be removed and disposed of safely as insertion of the plug into the socket is likely to cause electric
hazard. A replacement plug should be wired according to following description.
Important
This appliance must be earthed. The wires in the cord set are coloured thus:
BLUE- Neutral, Brown-Live, Green& Yellow-earth
(For detachable plug only)
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals inyour plug, proceed as follows:
The wire that is coloured Green& Yellow must be connected to the terminal in the plug that is
Advertisement
