Bowers & Wilkins PX Manual page 5

The PX Bluetooth indicator will flash continuously
while pairing is underway and will also provide
audible feedback when pairing is established.
Note: If your Bluetooth audio source device does
not support "simple" pairing and requests a four
digit code, enter '0000'.
Once a connection has been established, ensure
that PX is selected as the speaker output for the
Bluetooth source device. Audio will then be heard
through PX.
Note: If pairing fails the indicator will flash in
2 second bursts. The most common reasons for
pairing failure are signal interference and distance
between the two devices. It is good practice to
have the two devices relatively close to each
other when pairing.
To disconnect a Bluetooth source device from
PX press the Bluetooth button twice in quick
succession. This will disconnect all Bluetooth
connected devices. PX will provide audible feedback
when Bluetooth is disconnected.
PX paired device memory can be cleared by
pressing and holding Volume – and Bluetooth button
for 2 seconds. The indicator will flash and PX will
restart once its memory has been cleared.
7. Controlling Bluetooth Audio
The PX Play/Pause, Volume + and Volume – buttons
can be used to control Bluetooth audio:
Note: The buttons are not operational when PX is
used in passive mode with a wired connection.
To increase volume press and hold the Vol + button.
To decrease volume press and hold the Vol – button.
To play audio press and release the Play/ Pause
button.
To pause audio press and release the Play/ Pause
button.
To select the next track press the Play/ Pause button
twice in quick succession.
To select the previous track press the Play/ Pause
button three times in quick succession.
8. ANC
ANC will be set to 'Off' as default and can be
activated by pressing the ANC button on the side of
the right ear piece. A quick press of the ANC button
will toggle the On/Off state of the ANC Mode that
has been selected by the user in the App. A longer
press will toggle the Sound Pass Through state.
Note: Sound Pass Through should work with or
without music streaming, i.e. any time ANC is
"On".
9. Using a mobile phone with your PX
To answer a call press and release the Play/Pause
button.
To reject a call press the Play/Pause button for
2 seconds.
To end a call press and release the Play/Pause
button.
A Bluetooth stream playing while a telephone call is
taken will be paused. It will resume when the call is
ended.
10. PX wired connection
In addition to operating wirelessly, your PX can be
connected to a music source using the supplied
audio cable. Cable connection is useful if the battery
is low or if PX is to be used with a non-Bluetooth
audio source device.
To connect the supplied cable to your PX take one
end of the connection cable and carefully insert it
into the socket beneath on the right ear piece.
The audio cable must be disconnected for PX to
switch on and connect via Bluetooth, however its
battery can be charged while the audio cable is
connected.
Note: Connecting the audio cable will
automatically switch off the Bluetooth and
powered elements of PX. PX will not however
switch on automatically when the audio cable is
disconnected.
Diagram 5
Reboot
11. Reboot
To perform a reboot use a straightened paper-clip to
press and hold the Reboot button for two seconds
as illustrated in Diagram 5. The headphones will turn
off, press Power on and reboot will be complete.
Note: Performing a reboot will not clear the
paired device memory.
12. Cleaning your PX
Clean your PX by using a damp cloth and dabbing
the leather until clean, do not rub the cloth on the
leather. Do not use cleaning detergents or leather
polish, doing so may cause damage to the product.
5