Bluetooth Pairing; Wearing - Bowers & Wilkins PX Manual

4. Switching On and Off
To switch PX on slide the power button to the right
and hold for 1 second. To switch off slide the power
button to the right and hold for 2 seconds. PX will
provide audible feedback as it switches on or off.
Note: If PX is left switched on but inactive for
more than 10 minutes it will automatically turn off
to save battery power. It can be woken by sliding
the power button to the right.
5. Wearing your PX
Using your headphones correctly will help ensure
that their performance reaches its full potential. First,
identify the left and right ear pieces. Identification
legends are engraved on the metal hinge below the
headband.
This is illustrated in Diagram 3.
Now unfold the headphones and slide them on to
your head with the headband adjusted so that each
ear piece sits comfortably over the ear.
This is illustrated in Diagram 4.
It is recommended that you fold and return your
headphones to their pouch when not in use.
6. Bluetooth Pairing your PX
To connect your PX to a Bluetooth enabled audio
device it must first be "paired" with the device. Once
paired, a Bluetooth device and PX will "remember"
each other and be able to connect when within
range.
PX can remember up to eight paired Bluetooth
devices. The first paired device is automatically
designated as the "primary" device. Additional
devices are designated as "secondary" devices.
The primary device will automatically connect when
PX is powered on and within range. Secondary
devices will not connect automatically when in
range but must be connected using their Bluetooth
settings menu.
At any time, a press of the Bluetooth button will
force PX to connect to the primary device, if it is
within range.
It is possible for two devices to be connected to PX
simultaneously, however, audio will only be streamed
from one device at any one time.
To pair a Bluetooth device with PX follow the steps
described below.
With PX switched on, press and hold the Bluetooth
button for 2 seconds. The indicator will flash blue
and PX will provide audible feedback as it enters
"pairing" mode.
Note: PX will automatically exit from Bluetooth
pairing mode if no device is paired within 5
minutes.
Open the Bluetooth settings on the source device
and ensure Bluetooth is switched on. Once
discovered, PX Bowers & Wilkins will appear as
an available Bluetooth device. Select PX Bowers &
Wilkins and close the Bluetooth settings.
Diagram 3
Identifying left and right
Diagram 4
Adjusting the earpiece.
4