Replacing The Hard Disk Drive - Lenovo ThinkCentre 6393 Hardware Installation And Replacement Manual

5. Position the new heat sink on the retention module so that the four screws are
Figure 11. Installing the new heat sink
6. Go to Chapter 4, "Completing the parts replacement," on page 27.

Replacing the hard disk drive

This section provides instructions on how to replace the hard disk drive for models
with a local hard disk drive installed. For models that use a remote hard disk drive
accessed through the Secure Managed Client - Storage Array (SMC - Storage
Array), contact your network or storage administrator.
16
Hardware Installation and Replacement Guide
aligned with the posts on the system board. Tighten the four screws to the heat
sink to secure it on the system board.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Important
When you receive a new hard disk drive, you also receive a set of Product
Recovery discs. The set of Product Recovery discs will enable you to restore the
contents of the hard disk drive to the factory-installed state. For more
information on recovering factory-installed software, refer to "Recovering
software" in your ThinkCentre User Guide.