Warnings And Cautions - Intec CVD650LCD User Manual

Warnings and Cautions

Warnings
Do NOT attempt to connect other electrical devices to the power wire harness of the Car Vision® System as this can
cause an over current situation which can lead to electrical shock or fi re.
If at any time you see or smell smoke coming from the Car Vision® System, stop driving, exit the vehicle and disconnect
main power. Check the system and remove any damaged components before you resume normal vehicle operation.
Do NOT attach the wiring to any moving parts, across sharp edges or close to heat sources as this may cause shorting of
the wires and may lead to a fi re or electrical shock.
When installing the system be sure to use only INTEC supplied brackets. The Car Vision® camera must be insulated from
the vehicle body. The supplied camera bracket provides the required insulation. Failure to do so could result in a fi re and
lead to property damage or personal injury.
Do NOT install the camera in any area that allows it to extend out past the vehicle as this can cause injury if it were to
come in contact with people walking around the vehicle.
Never use fuses of a larger rating than those supplied with your Car Vision® System. Use of larger rated fuses can cause
excessive current through the system if a short occurs and could lead to a fi re.
Confi rm that the orientation of the image on the display is proper. Rear facing cameras should yield a mirror image, where
items on the left of the vehicle appear on the left side of the monitor.
Cautions
Before you begin driving, be sure the display controls are adjusted properly. This will avoid unnecessary distractions while
driving.
When installing the camera system be certain that all items are secure. Items that are not secure or mounted in an
unstable manner can come loose and cause damage or personal injury.
Do NOT attempt to open or service your equipment. Removal of the product enclosure can lead to electrical shock. No
user serviceable parts inside.
You should not attempt to make any adjustments to the Car Vision® System while driving as this can lead to an accident.
Only make adjustments when the vehicle is stopped.
Keep the Car Vision® System clean and free from dirt, snow and ice. If the camera glass or display panel becomes dirty,
clean them before use. If they are covered with snow and/or ice, it should be cleared off before use. Failure to do so could
lead to an accident.
When running a cable from the exterior to the interior of a vehicle, care needs to be taken to seal the entry point. Failure
to do so could allow in exhaust fumes, other toxic gases or water.
Page 5