Vacuuming In The Container - Siemens BV830EN.1B Instruction Manual

Cancelling the vacuuming process
When air is being extracted from the bag, touch the
Stop symbol to cancel the process early.
The appliance displays the vacuuming level until it is
reached.
The bag is not heat-sealed. The lid opens slightly and
the chamber is ventilated. An acoustic signal sounds.
You can now remove the vacuuming bag from the
chamber.

Vacuuming in the container

Vacuum the food in a suitable vacuuming container in
order to preserve the food for longer.
Suitable vacuuming containers
Only use containers that are suitable for vacuuming
food. Commercially available products are different
when it comes to the quality of the food and the
material.
The vacuum hose that is enclosed with this appliance
has an inner diameter of 3 mm. To ensure that the hose
fits, you may require an adaptor for your container. In
many cases, these adaptors are already included with
the vacuuming containers.
Proceed as follows:
Open the glass lid.
1.
Plug the vacuuming adaptor into the air outlet.
2.
Secure the hose to the vacuuming adaptor and the
3.
vacuuming container.
Touch the 5 symbol to select a vacuum-sealing
4.
level.
Touch the Start symbol to start the vacuum-sealing
5.
process.
The vacuum-sealing process will now start. The
vacuum-sealing level indicators will flash blue one after
the other until the value you selected has been reached.
The vacuuming levels stop pulsating as soon as the
target value has been reached. The vacuuming level
that has been reached lights up and an acoustic signal
sounds. You can now detach the hose from the
container and the external vacuuming adaptor.
If larger bubbles form, cancel the vacuuming
Note:
process.
Cancelling the vacuuming process
When air is being extracted from the bag, touch the
Stop symbol to cancel the process early.
The appliance displays the vacuuming level until it is
reached.
You can now detach the hose from the container and
the external vacuuming adaptor.
Carrying out the drying program for vacuum
pump
When vacuuming food, the smallest volume of water
gets into the vacuum pump system. This effect is
exacerbated when you are vacuuming liquids or
extremely moist food. For this reason, the appliance
comes with a drying function, which further removes
any liquid that gathers in the pump.
If the ¢ symbol is lit white, it is recommended that you
run a drying cycle. However, at this point, you can
continue to use the appliance as normal if you wish.
If the ¢ symbol is lit red, you must run a drying cycle.
Proceed as follows:
Tightly close the glass lid and hold it there.
1.
Touch the ¢ symbol.
2.
Drying will now start. It will take between 5 and 20
minutes. The ¢ symbol will flash blue while drying is in
progress.You can close the vacuum-sealing drawer
while drying is in progress.
At the end of the program, the chamber is ventilated
and an acoustic signal sounds. You can now open the
glass lid.
It may be the case that a single drying cycle is
Note:
not sufficient. If, after one drying cycle, the ¢ and
: symbols are lit red, there is still moisture in the pump
system. Wait until the : symbol goes out and start
another drying cycle.
Operating the appliance
en
9