Timer Operation - Tayosan SRE 3001 Instruction Manual

TIMER OPERATION

For SRE 3001 / FR 32
For SRE 4600 / FR 46
TIMER OPERATION
Timer operation is available only after the current time is entered.
*When < TIMER CONTROL > key is pressed, buzzer sounds as the current time is displayed.
EX: To program AM. 6:35
1.
Press < ON > key.
Operation lamp lits.

*This step is not necessary while the heater is already in operation.
2.
Press < TIMER CONTROL > key.
Operation stops and the operation lamp goes off.

Timer operation lamp lits, and digital indicator shows restarting time 6:00.

3.
Enter restarting time
Time indication changes by minute at each pressing of time key.

Press the key for a few seconds and the figure will continue to change.

After the minutes reaches 10, figure changes by every ten minutes.

Press the key one at a time for minute adjustment.

4.
Press <TIMING> key, and set the working duration.
[--h] indicates the combustion goes on without stop, [10h] indicates 10 hours, [9h] does 9

hours, ... and [1h] does 1 hour of combustion.
5.
Timer programming is now completed.
*Confirm that the timer lamp is lit.
*Digital indicator shows the mode selected.
The Unit restarts at the programmed time.

NOTES:
The stating hour of the TIMER can be modified when you want. You must only press
on the switch MODE and adjust the hour with the button + and –.
TIMING
49