Toro TimeCutter ZS 5000 Installation Instructions

Belt Guard Kit
TimeCutter
Model No. 120-7790
Do not supply these instructions to the customer.
These instructions are for a dealer to install additional belt guards on units sold in France.
Safety
Safety and Instructional
Decals
Safety decals and instructions are easily
visible to the operator and are located
near any area of potential danger.
Replace any decal that is damaged or
lost.
120-1119
1. Fire hazard—read the Operator's Manual.
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® ZS 5000 Riding Mower
Installation
Preparing for Installation
No Parts Required
Procedure
Important: Refer to the Operator's Manual if you
are unfamiliar with the specifics of operating this
machine before proceeding. The manual contains
important information about safely operating the
machine. If you do not know this information, you
could seriously injure yourself or others.
1. Park the machine on a level, smooth surface with
2. Check the loose parts bag and verify that it contains
3. Remove the mowing deck and slide it out from
Register at www.Toro.com.
Installation Instructions
1
sufficient space to access both sides of the mowing
deck.
WARNING
Before working on the machine, stop the engine,
set the parking brake, remove the ignition key,
and disconnect the spark plug wire.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect
the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does
not accidentally contact the spark plug.
all the parts listed in this document.
under the traction unit; refer to the Operator's Manual
for this model.
Form No. 3368-785 Rev A
Original Instructions (EN)
Printed in the USA.
All Rights Reserved