3M TD4i Installation & Operation Manual page 7

FCC
The equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This device complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines and RSS‐102 of the ISED radio frequency (RF) Exposure rules.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna, 2. Increase the separation between the equipment and the receiver, 3.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, 4. Consult
the dealer or an experienced radio/TV technician for help.
3M Electronic Monitoring has not approved any changes or modifications to this device by the user. Any changes or
modifications could void the user's authority to operate the equipment.
WEEE
This symbol according to the European Directive indicates that the Waste of Electrical and Electronic
Equipment (WEEE) must not be disposed of as unsorted municipal waste and must be collected separately.
Please contact an authorized representative of the manufacturer or an authorized waste management
company for information concerning the decommissioning of your equipment.
FCC ID: LSQ-TD4i-433
FCC ID: LSQ-IDEU-830-2
FEDERAL COMMUNICATIONS COMMISSION (FCC)
Part 15 STATEMENT
7
3M Electronic Monitoring