Table of Contents
Advertisement
wax. This is for added weight so the wind won't blow it over. This
is also the reason we use thick walled PVC pipe.
The 30 or 60 degree pipe joints are used to angle the legs out like
a tripod. The center pipe joint has a hole drilled in it for the coax to
pass through. Make sure and seal this hole with sealant before
completion.
The 'X' joint holds the antenna mast in place as well as all three
legs. You will also need 3, 2 1/2" long pieces of pipe to join the 30
or 60 degree pipe joints to the 'X'. Glue the center leg in place, but
don't glue the outer two until you have leveled the antenna in your
mounting place. The angle of the roof can be compensated for in
this manner. Glue these last, and then wait for the glue to dry
before standing up.
WSR-ANT • 15
Advertisement
Table of Contents
