Page 1
SKINNY JIB USER MANUAL (2” and 4” Configuration) INCLUDED INSIDE Safety Rules • Parts Check Lists and Photos • Step by Step Instructions • EZ FX Policy and Procedures • WATCH THE INSTRUCTIONAL VIDEO A companion video is available at http://www.ezfx.com/ez-crane-set-up-video/...
Page 2
Inversely, don’t remove the camera until you have secured it and removed the counter weights first. Be aware of pinch points on the Skinny Jib and avoid placing items such as cables or body • parts in an area where moving parts can cause damage or harm someone.
Page 3
Skinny Jib PART NAMES and Skinny Jib CHECK LIST HARD CASE A - Center Post B - Camera End Beam C– Tool and Accessories Bag SLEEVE CASE (Red Tag) D - 2 Foot Tail Beam E - 4 Foot Jib Beam (logo)
Page 4
CANVAS TOOL BAG CHECK LIST A- Sliding Counter Weight H- Bowl Tripod Mounting Hardware B- Counter weight Bar and Spring Clips (Plate, Shaft, Knob, Washer) I- Direct Camera Mounting Screw C- Jib Yoke Rest J- Flat Base Fluid Head Mounting Hardware D- Level K- T Handle Hex tool E- Bungee cords Tie Downs (8)
Page 5
Skinny Jib SETUP INSTRUCTIONS - 2’ Configuration STOP/ NOTE: The Skinny Jib can be used at 2’ or 4’ Configuration. Below are the instructions for the 2’ Configuration. (Pages 5, 6 & 7) Refer to pages 8, 9 and 10 for instructions on the 4’ configuration A companion video is available at www.ezfx.com/SkinnySetUp...
Page 6
Skinny Jib SETUP INSTRUCTIONS - 2’ Configuration STOP/ NOTE: The Skinny Jib can be used at 2’ or 4’ Configuration. Below are the instructions for the 2’ Configuration. (Pages 5, 6 & 7) Refer to pages 8, 9 and 10 for instructions on the 4’ configuration...
Page 7
Skinny Jib SETUP INSTRUCTIONS - 2’ Configuration STOP/ NOTE: The Skinny Jib can be used at 2’ or 4’ Configuration. Below are the instructions for the 2’ Configuration. (Pages 5, 6 & 7) Refer to pages 8, 9 and 10 for instructions on the 4’ configuration 13.
Page 8
Skinny Jib SETUP INSTRUCTIONS - 4’ Configuration STOP/ NOTE: The Skinny Jib can be used at 2’ or 4’ Configuration. Below are the instructions for the 4’ Configuration. (Pages 8, 9 & 10) Refer to pages 5, 6 and 7 for instructions on the 2’ configuration A companion video is available at www.ezfx.com/SkinnySetUp...
Page 9
Skinny Jib SETUP INSTRUCTIONS - 4’ Configuration STOP/ NOTE: The Skinny Jib can be used at 2’ or 4’ Configuration. Below are the instructions for the 4’ Configuration. (Pages 8, 9 & 10) Refer to pages 5, 6 and 7 for instructions on the 2’ configuration...
Page 10
Skinny Jib SETUP INSTRUCTIONS - 4’ Configuration STOP/ NOTE: The Skinny Jib can be used at 2’ or 4’ Configuration. Below are the instructions for the 4’ Configuration. (Pages 8, 9 & 10) Refer to pages 5, 6 and 7 for instructions on the 2’ configuration 13.
Page 11
ON CREDIT CARD PAYMENTS EZ FX, Inc. reserves the right to authorize the card before the product is shipped. If the card is declined then EZ FX, Inc. is not obligated to ship out the products until an valid card is obtained.