Breville Fresh & Furious BBL620 Instruction Book page 10

MANUAL SPEED SELECTION
ON | OFF
The ON | OFF button powers the unit into
READY mode.
Speed Control Selection
There are 5 electronic speed buttons from MIX
through to LIQUIFY.
MIX combines more delicate foods with a
folding motion, and is good for combining wet
and dry ingredients.
LIQUIFY is the fastest setting and is ideal for
breaking down ingredients to prepare soups,
make cocktails and other finely blended
mixtures.
Select the required speed (1 to 5) by pressing
the corresponding speed button. The blender
will start to operate and the selected speed
button will illuminate. The ON | OFF button
will illuminate and cease to flash.
The LCD timer screen will start counting up
in one second increments until 60 seconds is
reached.
When 60 seconds is reached, the blender will
automatically stop blending and the selected
speed button illumination will turn off. This is a
safety feature and
restricts wear on the motor.
The ON | OFF button will illuminate and flash.
After a few seconds the LCD timer screen will
revert to '00'.
10
• To stop blending at any time, press the
selected speed button. The ON | OFF button
can also be pressed, but this will also turn the
appliance off and all illuminations will go out.
• The speed can be changed at any time during
the blending process. Each time a new speed
is selected its button will illuminate and the
previous speed button illumination will go
out.
Count-up Timer
The blender timer counts up in seconds as
it blends on one of the 5 electronic speeds.
When using the timer this way, the blender will
automatically stop after 60 seconds.
PRESET PROGRAMS
Your blender features three additional
functions, 'AUTO PULSE/ ICE CRUSH',
'GREEN SMOOTHIE' and 'SMOOTHIE'.
These three pre-programmed cycles
automatically adjust the blending time
and speeds to optimize blending results.
Select the required function by pressing the
corresponding function button. The blender
will start to operate and the selected function
button will illuminate. The ON | OFF button
will illuminate and stop flashing. The LCD
timer screen will start counting down in one
second increments until '00' is displayed. Press
any pre-set program button to activate the
program – press the button again to deactivate.