JVC LT-32DP9BJ Instructions Manual page 35

PR Installation menu (continued)
Signal Check
Signal level: Poor < Acceptable < Excellent
Signal Check
6
Service
Channel 69
22
1 BBC ONE
D
32
2 D BBC TWO
To check another
61 
69
broadcast channel
Signal : Acceptable
Signal Quality 50
Signal Strength 44
The "Channel" is the frequency of the digital broadcasting. It differs from the
channel number displayed on the TV.
Auto Demonstration
On Set to automatically start the demonstration
Off Function is turned off
Make sure the "Auto Demonstration" is set to "Off", when using "Photo

Viewer", "Retuning", "Auto Scan" , "Manual Scan", or "Update Scan".
When Timer (P. 21) is set, Auto Demonstration can not be selected.

Do not connect USB device when "Auto Demonstration" is set to "On".

When set to "On", it automatically enters demonstration every time

no operation is made for approximately 3 minutes. To stop automatic
demonstration, set "Auto Demonstration" to "Off".
For details of "100Hz Clear Motion Drive II" demonstration, refer to page 41.

Check the broadcast signal
1 select
2 set
Demonstration and slide show of this TV's
function
Factory Setting
Are you sure you want to delete the PR list and
reset all settings?
Yes No
The TV will switch off when reset is completed.
Please switch the TV back on.
1 select "Yes"
Initial setting will start again.
"Initial settings" (P. 13)
2 start
Select "Yes" in "Factory Setting" (will enter standby), then turn on from

standby and start the "Initial settings" (P. 13).
Retuning menu
You can set the TV to restart the initial setting. For details refer to step 2 in
"Initial setting" (P. 13)
Using the menu functions
Initialise the settings