JVC LT-32DP9BJ Instructions Manual page 15

Initial settings (continued)

Start auto scan
Register channels
Auto Scan
Step 6: Auto Scan will start when "Start" is selected
Start
Cancel
Auto Scan
Scan Completed
Digital
13 Service Found
Analogue
14 Service Found
100%
If you can not register channels, refer to "When you cannot watch TV

channels" (P. 14).
You can edit the channels after the initial settings. For details, refer to

"Edit PR" (P. 33). To edit PR
Some digital channels cannot be watched on this TV. For details,

refer to page 40.

Finish
To the previous screen
Æ

If the "Menu Language" does not appear or if you wish to make changes

later, refer to "Factory Setting" (P. 34) or "Retuning" (P. 34) for channel
settings.
Auto Scan
Digital
13 Service Found
Analogue
1 Service Found
51%
(green)
Æ
When you cannot watch TV channels

Check the following points
Is the TV connected correctly to the aerial?

Change the direction of the indoor aerial.

Note
You can check the broadcast signal level of the channel you

are watching. For details, refer to "Signal Check" (P. 34).

Set digital channels using "Factory Settings". For details, refer to
"Factory Settings" (P. 34)
If you still cannot watch digital channels after following the steps
above, there may be a problem with your aerial or its cable. Or, the
signal may be too weak. Consult your retailer
Æ

Setting up your TV