Samsung ML-331 series User Manual page 2

Regulatory information
You must have a 13 amp fuse in the plug, adaptor, or at the
distribution board.
19
Declaration of conformity (European
countries)
Approvals and Certifications
The CE marking applied to this product symbolizes
Samsung Electronics Co., Ltd. Declaration of Conformity
with the following applicable 93/68/EEC Directives of the
European Union as of the dates indicated:
Hereby, Samsung Electronics declare that this product is in
compliance with the essential requirements and other relevant
provisions of:
• ML-331x Series, ML-371x Series: Low Voltage Directive (2006/
95/EC), EMC Directive (2004/108/EC)
• ML-371xDW: R&TTE Directive (1999/5/EC)
The declaration of conformity may be consulted at
www.samsung.com/printer, go to Support > Download center and
enter your printer (MFP) name to browse the EuDoC.
January 1, 1995: Council Directive 2006/95/EC Approximation of
the laws of the member states related to low voltage equipment.
January 1, 1996: Council Directive 2004/108/EC (92/31/EEC),
approximation of the laws of the Member States related to
electromagnetic compatibility.
March 9, 1999: Council Directive 1999/5/EC on radio equipment
and telecommunications terminal equipment and the mutual
recognition of their conformity. A full declaration, defining the
relevant Directives and referenced standards can be obtained from
your Samsung Electronics Co., Ltd. representative.
European radio approval information (for products
fitted with EU-approved radio devices)
Low power, Radio LAN type devices (radio frequency (RF) wireless
communication devices), operating in the 2.4 GHz/5 GHz band, may
be present (embedded) in your printer system which is intended for
home or office use. This section is only applicable if these devices are
present. Refer to the system label to verify the presence of wireless
devices.
Wireless devices that may be in your system are only qualified for use
in the European Union or associated areas if a CE mark
with a Notified Body Registration Number and the Alert Symbol
is on the system label.
The power output of the wireless device or devices that may be
embedded in you printer is well below the RF exposure limits as set
by the European Commission through the R&TTE directive.
5. Appendix 97