Mitel 5000 CP Configuration Manual
  1. Manuals
  2. Brands
  3. Mitel Manuals
  4. VoIP
  5. 5000 CP Phone
  6. Configuration manual
Mitel 5000 CP Configuration Manual

Mitel 5000 CP Configuration Manual

Setting up babytel service
Hide thumbs Also See for 5000 CP:
1
2
3
4
5
6

Advertisement

Table of Contents

See also: User Manual
babyTEL Mitel 5000 CP Configuration Guide
Introduction
The information in this document is intended as a general guide to help you set up the babyTEL service on
your SIP compatible telephone system. It contains only babyTEL-specific parameters that need to be
configured on your Mitel 5000 CP. For full and proper functioning of the babyTEL service and all other
features, your Mitel 5000 CP should be set up according to the detailed instructions provided by the
manufacturer in their configuration guide.

Step 1 - Gather all the necessary information

Your User ID and Web password were provided to you in the Signup Confirmation email. Go to the
babyTEL website (www.babytel.net) and login using your ID and password. (The login command can be
found at the top right corner of the page.) Click on babyTEL Service to expand the menu and then click on
SIP Parameters. A page similar to the example shown below will be displayed, with values relevant to
your account.
Please have this information at hand when you configure your system.
CU-v2.1
babyTEL Mitel 5000 CP Configuration Guide
page 1 of 6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 5000 CP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Mitel 5000 CP

Summary of Contents for Mitel 5000 CP

  • Page 1 SIP compatible telephone system. It contains only babyTEL-specific parameters that need to be configured on your Mitel 5000 CP. For full and proper functioning of the babyTEL service and all other features, your Mitel 5000 CP should be set up according to the detailed instructions provided by the manufacturer in their configuration guide.
  • Page 2 Note: Values for the Items shown in blue should be taken from the SIP Parameters page for your your account. When entering data, please do not include the brackets "<" and ">". 1. On the Mitel 5000 CP programming interface open the Configuration screen of the SIP Trunk Group: + System...
  • Page 3 Mitel 5000 CP Configuration Guide Note: SIP messages are sent to <Outbound Proxy> and to UDP port <Outbound Proxy port>. 3. Select the Authentication menu and enter required values as shown below: CU-v2.1 babyTEL Mitel 5000 CP Configuration Guide...
  • Page 4 Mitel 5000 CP Configuration Guide 4. You can now set the Calling Party information for the trunk group as shown below: Note: It may be necessary to include Display Name between quotes as in “Display Name”. 5. Please pay particular attention to “Route Call Using To Header” in the Configuration menu. This parameter must be set to ‘Yes’...
  • Page 5 Mitel 5000 CP Configuration Guide Note that if “Route Call Using To Header” is not available on that screen, check that you have “On- Line Monitor” checked to view this field. If checked and still not available, you will need to upgrade the Mitel to a minimum of 5.1.
  • Page 6 Mitel 5000 CP Configuration Guide Contact If you require assistance you can contact us 24 hours a day, 7 days a week, by email at service@babytel.net. You can also reach us by phone 7 days a week from 9 AM to midnight, Eastern Time at: Canada Montréal: 514 201-6550...

Table of Contents