Chapter 4 Hardware Connection - Netis NW5222008M1 User Manual

2 CPU
3 LAN Link
4 LAN
Speed
5 LAN
RX/TX
6 Wireless
RX/TX

Chapter 4 hardware connection

Begin by finding a good place to set up your wireless broadband. Some things
to consider:
Keep the access point as central in your work area as possible. Signal
strength and speed fall off with distance.
Higher is often better. For instance, set it up on the top shelf of a bookcase
rather than the bottom one, if possible.
Prior to connecting the hardware, make sure to power off your Ethernet device
and Wireless Access Point (AP). Then follow the steps below to connect the
related devices.
Step 1: Connect your computer to the LAN port.
Attach one end of the Ethernet cable with RJ-45 connector to your hub, switch
or a computer's Ethernet port, and the other end to one of the LAN ports of your
AP.
Step 2: Connect the power adapter.
Connect the single DC output connector of the power adapter to the power jack
on the side of the AP. Then plug the Power Adapter into an AC outlet.
Step 3: Power on the following devices in this order:
HUB or Switch, AP, and PCs
Wireless Access Point User manual
otherwise, it is off.
ON The LED will be dark for a few seconds
when the system is started. After that,
the LED will stays green to show the
Wireless AP is working normally. If the
LED stays blink/dark that means the
system failed, you need to contact your
agent or try to reboot the system.
Flashing LAN is connected.
Flashing LAN has Activity (ACT) data being sent or
Received
Flashing LAN has Activity (ACT) data being sent or
Received.
Flashing Wireless has Activity (ACT) data being
sent or Received.
Page 6 of 36