Table of Contents
Advertisement
VarioSelectCDE 18-27 TECHNOTHERM
7. Elektroanschluss
Electrical installation from above
Check that the power supply is switched off prior to electrical
connection
1. Open the prepared breaking point (S) in the upper part of the
appliance by pressing with a blunt implement (e.g. srewdriver).
2. Slit the grommet to match the cable size. The opening in the
grommet should be slightly smaller than the cross-section of the
cable in order to ensure optimum protection against water. Fit the
grommet into the opening. The protection grommet must be used!
3. Dismantle the cable roughly 6 cm above the point where it
emerges from the wall. Hold the prepared appliance so that you
can route the cable into the grommet with the other hand.
4. Place the appliance on the heater bracket so that the threaded rod
of the wall bracket fits in the provided hole of the appliance
5. Unscrew the fastening screw of the connecting terminal. Displace
the connecting terminal to the upper foot. Affix the connecting
terminal again.
6. Strip the cables and plug them in the connecting terminals
according to the wiring diagram. The appliance must be earthed.
7. Place the hood on the appliance and screw in the fastening screw.
After that you can reinsert the faceplate.
12
Advertisement
Table of Contents
