Audi TT Coupe 2014 Owner's Manual page 99

Switching on and off
Applies to vehicles: with park assist
Fig. 106
Centre console: Switch for park assist
Fig. 107 Instrument cluster: Looking for a parking space.
® parallel to the roadside,®
side
.. To
park parallel to the roadside, press the
I@ button once c::>
Fig. 107
c:> will appear on the infotainment sys­
tem. Or:
.. To
park perpendicular to the roadside, press the
I@ button twice.
.. The LED in the I@ button is lit if the park assist
is switched on.
.. To
switch off the park assist, press the I@ but­
ton. The LED in the I@ button will go out.
0
N
co
,-j
\D
U'l
N
U'l
,-j
perpendicular to the road­
Fig. 106.
Display®
Display@ will appear.
Looking for a parking space
Applies to vehicles: with park assist
Fig. 108
Instrument cluster: Prompt to keep driving for­
wards (a parking space has been detected)
The section below describes how to park parallel
to the roadside. The procedure for parking per­
pendicular to the roadside is similar.
Important: For the best parking result, you
should maintain a distance of approx. 1 metre to
the row of parked cars.
®
.. Activate the turn signal for the side on which
you want to park.
.. To park parallel to the roadside, drive forwards
at not more than 30 km/h. Or:
.. To
park perpendicular to the roadside, drive for­
wards at not more than 20 km/h.
.. The system will display a parking space when it
finds one c::>
parking space is suitable for your vehicle .
If you exceed a speed of about 50 km/h, the park
assist will be switched off.
The park assist will display a parking space only if
it is long and wide enough for the vehicle.
If you operate the left turn signal, the display will
show the left side of the road (and vice-versa).
Note
- You can activate the park assist after you
have already driven past a parking space (as
long as you were driving slowly enough). To
do so, press the I@ button and operate the
turn signal.
Parking aids
Fig. 108.
Please check that the
...
97