Redfish iDVM 510 User Manual page 6

W a r n i n g - R e a d b e f o r e u s i n g t h e M e t e r
Use the Meter only as specified in this manual or the protection
provided by the Meter might be impaired.
Do not use the Meter or test leads if they appear damaged, or if the
Meter is not operating properly. If in doubt, have the Meter serviced.
Always use the proper terminals, switch position, and range for
measurements.
Verify the Meter's operation by measuring a known voltage.
Do not apply more than the rated voltage, as marked on the Meter,
between the terminals or between any terminal and earth ground.
Use caution with voltages above 30 V AC rms, 42 V AC peak, or
60 V DC. These voltages pose a shock hazard.
Disconnect circuit power and discharge all high-voltage capacitors
before testing resistance, diode function, or continuity.
Do not use the Meter around explosive gas or vapor.
When using the test leads, keep your fingers behind the finger guards.
Do not open Meter enclosure as this will void the warranty.
Extended wireless connection to mobile device can cause the battery
on the Meter to drain rapidly.
Important safety information.
High voltage with danger.
Ground.
Double Insulation (Class II safety equipment).
Fuse must be replaced as per the specification herein.
AC (Alternating Current)
DC (Alternating Current)
AC & DC (Both direct and Alternating Current)
Accord with the related EU laws and regulations.
Conforms to UL STD. 61010-1, 61010-2-030 and 61010-2-033;
Certified to CSA STD. C22.2, NO. 61010-1, 61010-2-030 and
61010-2-033.
It is applicable to test and measuring circuits connected to the
distribution part of the building's low-voltage MAINS installation.
It is applicable to test and measuring circuits connected at the
source of the building's low-voltage MAINS installation.
6