Cisco 12012 Installation Instructions Manual page 9

Proceeding from the bottom port on the line card (for line cards with multiple ports only),
Step 3
disconnect the network interface cable from the each port on the line card. (Refer to
Figure 4a.)
Carefully remove the interface cable from the vertical cable-management bracket clips.
Step 4
(Refer to Figure 4b.)
Step 5 Carefully remove the interface cable from the vertical cable-management bracket clip
nearest the line card port. (Refer to Figure 4c.) Set the interface cable aside.
Repeat Step 3 through Step 5 for the rest of the interface cables attached to the line card.
Figure 4 Removing the Cables From a Vertical Cable-Management Bracket
Chassis
cable-management
tray
a
Line card
cable-management
bracket
Interface
cable
Cisco 12012 Gigabit Switch Router Cable- Management Kit Installation Instructions
Removing and Replacing the Cable-Management System
b
Cable clip Cable clips
c
9