Cleaning Of The Air Intake Filter - NewAir MINIDRYER36W Owner's Manual

2. Cleaning the filter. Separate the "exhaust vent
shroud," the "lint filter," and the "exhaust filter."
Clean the lint on the lint filter and exhaust filter
with a soft brush or vacuum cleaner. Do not
damage the filters (as shown in Fig. 2.)
3. Re-installing the filter. After cleaning the filter,
assemble in the sequence of the "exhaust
filter," the "lint filter," and the "exhaust filter."
Alight the recesses in the center with the
projection in the center of the drum. Make
sure that it is firmly inserted (as shown in
Fig. 3.)
The filter fixed in the bottom of the drum should also be cleaned with a
soft brush.

CLEANING OF THE AIR INTAKE FILTER

The filter should be cleaned once a month.
Remove by pulling outwards holding the upper
and lower ends of the air intake shroud. Remove
the filter inside the shroud and clean it with a soft
brush. Reassemble and install as before.
Slightly push upwards with your thumb until the latch hook disconnects, and then
remove.
CLEANING THE INTERIOR & EXTERIOR OF THE DRYER
1. Do not wash directly with water.
2. Do not use thinner, gasoline, or alcohol.
3. Do not use any type of spray cleaner when cleaning the interior. If dryer drum
becomes stained, clean the drum with a damp cloth.
4. Remove any residue before drying the next load.
5. Clean cabinet with mild soap and water. Do not use harsh or abrasive cleansers, this
could damage the dryer.
CAUTION: HOT SURFACE!! Do not touch the intake during the drying
cycle due to high temperatures.
15
A Name You Can Trust