Hard Drive Removal; Mirror Sd Card Removal/Insertion; To Reinsert A Hard Drive - Safety Vision OBSERVER 4112 HVR User Manual

Hard Drive Removal

To remove the hard drive from the HVR:
1.
Ensure the HVR is powered off.
2.
Insert the key into the hard drive
lock and turn it counter-clockwise.
3.
Turn the two hard drive thumb
screws counter-clockwise until
they are loose.
4.
Pull the hard drive firmly and
straight out.
Mirror SD Card Removal/
Insertion
The SD card access door is secured by
the hard drive and can only be opened
when the hard drive is removed.
Do not force the SD card into the slot
upside down or backwards.
Ensure the SD card's write protection
slider is in the "unlocked" position.
Do not remove the SD card until the
HVR is turned off.
1.
Open the SD card slot door from
the left edge.
2.
Insert an SD card into the SD card
slot label-side up, with the notch to
the right, until it clicks in place.
To remove the SD card, press the SD
card as far as it will go in the slot, then
allow it to "spring" out.
3.
Close the SD card slot door.

To reinsert a hard drive:

1.
Push the hard drive firmly all the
way into the HVR.
2.
Turn the two hard drive thumb
screws clockwise until they are
secure.
Do not over-tighten the thumb
screws. Use finger pressure only!
3.
Insert the key into the hard drive
lock and turn it clockwise.
OBSERVER 4112 HVR HARDWARE GUIDE
5