Advertisement
1. Installing the camera
1. Please install the device in time after it is taken apart to avoid the camera module being exposed to damp
environment for too long.
2. Before the installation, please make sure the installation surface is thick enough to sustain at least 3 x the weight
of the camera.
3. For the installation mode of side outlet, make sure the direction of side outlet is in accordance with that of the
installation position map when sticking the installation position map. Besides, pull the cable through the pedestal
cable slot before locking the screw.
1.1 Follow these steps to install your camera (see image above)
1. Unscrew the locking screw counterclockwise to release the pedestal.
2. Take out the installation map found in the accessories bag, paste it on a ceiling or wall and dig holes on installation
surface according to the position map.
3. Fix expansion bolts into the installation holes.
4. Adjust the pedestal location (pull the cable through side cable slot if it is side cable outlet).
5. Align the bolt fixing hole of device pedestal with the expansion bolt fixing holes of the installation surface; insert
the self-tapping screws into the expansion bolts and secure them firmly to fix the pedestal on the installation
surface (if it is top outlet, pull the cable through the outlet hole on the installation surface after the pedestal is
fixed firmly).
6. Insert the enclosure into the pedestal together with the dome body, turn the locking screws clockwise and fix
them preliminarily; rotate enclosure and dome body to a proper monitoring location.
7. Tighten the locking screws to fix it completely.
8. Your setup is complete!
|
6
Securview Victory Series
Advertisement
