CycleOps PowerTap SLC+ Quick Start Manual page 3

18561:Layout 1 10/30/2008
2) Hold [MODE] or [SELECT] - a single button press and hold of either [MODE] or [SE-
LECT] for 2 sec. Used for initiating a new mode or function.
3) Press [MODE] and [SELECT] - simultaneously press and release of both [MODE] and
[SELECT]. Used for initiating a new interval.
4) Hold [MODE] and [SELECT] - simultaneously press and hold both [MODE] and [SE-
LECT] for 2 sec. NOTE: If mode and select are released when "clr" is displayed, all data
will be erased. Used for initiating scrolling menu.
SCROLLING MENU:
SCROLLING MENU:
Find: If [MODE] and [SELECT] are released
When "Find" is displayed the computer will find
the PowerTap sensors.
clr: If [MODE] and [SELECT] are released when
clr is displayed ALL DATA WILL BE ERASED.
SEt: If [MODE] and [SELECT] are released
When SEt is displayed on the top level of the
Screen, a flashing "E" , d and t on the middle
Level and 12345 on the bottom level.
Note: Only the SLC+, SL+, Pro+ and 2.4+ have setup menus 2, 3, and 4.
11:51 AM
E= exit, return to ride mode
d= restore default settings
T= test mode
1 2 3 4 5 = setup menus
Page 3
3