Table of Contents
Advertisement
7. WAVE YOUR LEFT HAND The left sensor sends Control Change data to your synth to influence
the sound in a variety of ways. It is presently in Function 1: Pitch Bend mode. Play a steady note
with your right hand, and also wave your left hand. The display will show a cute spinny-graphic
that represents Bend Up and Bend Down – try it!
8. CHANGE THE FUNCTION Turn the FUNCTION knob to display numbers
to the functions shown in the table below, and on a label on the bottom of your Altura. After
the table there's a brief description of each function, with much more to learn in the Reference
Manual.
FUNCTION
NUMBER
NAME
1
Pitch Bend
2
Modulation
Note-On
3
velocity
Channel
4
volume
Portamento
5
Time
6
X-Y Mode
Send Channel
7
Select
• Function 1: Pitch Bend
Wave your hand in front of the left sensor. The display shows a cute spinny-thing to
represent Pitch Bend Up and Down. As you move your hand, the display spins and the
pitch bends. When you lock into the fully-bent pitch, either up or down, this symbol
appears: "
" Remove your hand to snap back to the "Neutral", or "No Bend" position,
0.
indicated with "
FULL BEND
DOWN
Turn the DATA FAR knob to display numbers
the number of semitones the pitch will change at maximum bend. On other devices, this
knob will have no effect or an unpredictable effect. Set to
Turn the DATA NEAR knob to display numbers
Neutral Zone in the air, separating the Bend Up and Bend Down zones. On startup, the
zone was set to 127: you will find a large piece of air where the pitch remains unaffected.
Change it to zero and the Neutral Zone diminishes.
CONTROLLER
NUMBER
1
Adjust size of neutral zone
2
n/a
5
7
The DATA and OCTAvE knobs set the max and min
User Defined
values transmitted by left and right sensors. KEY and
n/a
".
f
"NEUTRAL" OR
NO BEND
4
DATA FAR
Max. pitch bend range
Modulation maximum and minimum values
velocity maximum and minimum values
volume maximum and minimum values
Portamento Time maximum and minimum values
SCALE set the left and right CC#.
DATA FAR sets the MIDI Send channel (default 1)
. With a Macchiato Mini Synth, this sets
0 - 12
to disable Pitch Bend.
0
. This changes the size of the
0 - 127
, corresponding
1 - 7
DATA NEAR
(Macchiato only)
FULL BEND
UP
Advertisement
Table of Contents
