Troubleshooting - Ginnys WQP6-3208-US Instruction Manual

TROUBLESHOOTING

Problem
Dishwasher doesn't
Blown fuse or the
start circuit breaker has
tripped
Power supply isn't
turned on
Door isn't properly
closed
Water not pumped Kink in drain hose
from dishwasher
Filter clogged
Suds in the tub Improper detergent
Spilled rinse-aid
Stained tub interior Detergent with
colorant was used
16
TROUBLESHOOTING
Possible Causes What to do
Replace fuse or reset
breaker. Remove any
other appliances on
the same circuit
Make sure the dish-
washer is turned on
and the door is closed
securely. Make sure
the power cord is
properly plugged into
the outlet
Close the dishwasher,
making sure the door
latches
Check the drain hose
Check the coarse
filter: page 13
Only use detergent
specifically made for
dishwasher.
If suds occur, open
the door and let suds
evaporate. Add 1 gal.
of cold water to the
tub. Close and latch
the door, then start the
SOAK cycle to drain
out the water
Always wipe up spills
immediately
Make sure detergent
has no colorant
TROUBLESHOOTING...cont.
Problem Possible Causes
White film on the Hard water minerals
interior
There are rust stains The affected items are
on cutlery not corrosion-resistant
Knocking noise The spray arm is
knocking against an
item in a basket
Cloudiness on Combination of soft
glassware water and too much
detergent
Black or gray marks Aluminum utensils
on dishes have rubbed against
the dishes
Detergent left in Dishes block
dispenser cups detergent cups
Ginnys.com • 1.800.544.1590
What to do
See Cleaning & Care
Place only corrosion-
resistant cutlery in the
dishwasher
Interrupt the cycle and
rearrange the items
Use less detergent if
you have soft water
and select a shorter
cycle
Use a mild abrasive
cleaner to eliminate
marks
Reload the
dishwasher.
See page 11.
17