Before First Use; How To Operate - Ginnys WQP6-3208-US Instruction Manual

PART NAMES...cont.
INSTALLATION...cont.
CONNECTING THE DISHWASHER: (Refer to diagrams on page 7)
1. Remove the aerator from the faucet. Thread the Faucet Adapter with
gasket onto (or into) the faucet tap. If leaks occur, tighten with
vice-grips, do not over-tighten. Use thread tape if needed.
2. Connect the 6-sided connection of the drain hose (1) to the drain port
connection (1) on the back of the dishwasher cabinet. Do NOT
over-tighten (to avoid damage to the thread).
3. Connect the star-shaped connection of the inlet hose (3) to the inlet
port (3) on the back of the dishwasher cabinet. Do NOT over-tighten
(to avoid damage to the thread).
4. Connect the circular connection of the drain hose onto the longer
(bottom) male connection on the quick connect (11).
5. Connect the circular connection of the inlet hose onto the shorter (top)
male connection on the quick connect (10).
6. Attach the quick connect onto the faucet adapter by pulling down the
outer locking collar on the quick connect while pushing the quick
connect upward onto the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the
locking collar. Verify that the connection is secure.
8. Slowly open the hot water line and check for any sign of water leaks
at all hose connections. If leaks are located, immediately close the
water supply and repair the hose connections.
IMPORTANT:
Once you open the water supply line (even if it is closed immediately
thereafter), the inlet hose will be pressurized. To relieve water pressure
from inside the inlet hose (make sure the water line (faucet) is off): press
and hold the red pressure release button on the quick connect until the
flow of water stops.
WARNING:
FAILURE TO RELIEVE WATER PRESSURE BEFORE DISCONNECT-
ING THE QUICK CONNECT FROM THE FAUCET WILL RESULT IN
BACK-PRESSURE OVER-SPRAY. THE TEMPERATURE OF INCOM-
ING WATER CAN BE VERY HOT AND BACK-PRESSURE OVER-
SPRAY COULD CAUSE SEVERE BURNS AND/OR SCALDING.
8
INSTALLATION

BEFORE FIRST USE

Check the following before starting the dishwasher:
1. The dishwasher is level and fixed properly.
2. The inlet valve is open.
3. The hose connections on the dishwasher and faucet need to be on
tight to prevent leaking.
4. The inlet and drain hoses are not knotted.

HOW TO OPERATE

Detergent and Rinse Aid Dispensers:
TIP: If Using Detergent Tablets:
Detergent tablets of different brands dissolve at different speeds. Some
tablets cannot dissolve and develop their full cleaning power during short
cycles. Please use long cycles when using detergent tablets.
1. Detergent Dispenser: The dispenser must be filled before the start of
each wash cycle. This dishwasher uses less detergent than a
conventional dishwasher. More heavily soiled items may need more
detergent. Always add the detergent just before starting the dishwasher.
WARNING! Dishwasher detergent is
Push latch to open
corrosive. Take care to keep out of
reach of children.
• Filling the Detergent Dispenser:
Push the latch to open. Fill with detergent. Close the lid and press until
it locks in place. Please observe any manufacturer's warnings and
storage recommendations as stated on the detergent packaging.
Ginnys.com • 1.800.544.1590
9