Cleaning And Care - Ginnys WQP6-3208-US Instruction Manual

HOW TO OPERATE...cont.
5. Dishes and cutlery must not lie inside one another, or cover each other.
6. To avoid damage to glasses, they must not touch.
7. Cutlery should be in the cutlery basket with handles at the bottom.
8. Put long utensils in the horizontal position at the front of the upper basket.
9. Sharp items must be loaded in the cutlery basket with their points down.
10. Please do not overload your dishwasher. This is important for good
results and reasonable energy consumption
STARTING A WASH CYCLE:
1. Add detergent and rinse aid per instructions on pages 9 & 10.
2. Load dishes per instructions on page 11.
3. Plug in your dishwasher.
4. Connect the quick-disconnect to the faucet adapter. Make sure the hot
water supply is turned on to full pressure.
5. Close the door and press ON/OFF to turn on the power supply.
6. Select the wash cycle by pressing the Program Indicator Button.
• Heavy (pots & pans)
• Normal (dishes)
• Speed wash (glassware)
7. Then press START/RESET to start the dishwasher.
Note: When you press START/RESET button to pause during washing,
the LED display will stop blinking and the dishwasher will beep every
minute unless you press START/RESET to start.
CHANGING THE CYCLE AFTER THE WASH CYCLE HAS STARTED:
You can modify the washing cycle only if the dishwasher is early in the wash
cycle. Otherwise, the detergent may have already been released and the
dishwasher may have already drained. If this is the case, the detergent
dispenser must be refilled (see p. 9).Press "START/RESET" and hold for 3
seconds until the machine moves into standby mode. Then you can change
the program to the desired cycle setting.
ADDING A DISH AFTER THE WASH CYCLE HAS STARTED:
A forgotten dish can be added any time before the detergent cup opens.
1. Press "START/RESET" to pause
2. Open the door partially to stop washing
3. After the spray arms stop, open the door completely
4. Add forgotten dish and close the door
5. Press "START/RESET" and the dishwasher will continue its cycle after
10 seconds
12
HOW TO OPERATE
HOW TO OPERATE...cont.
AT THE END OF THE WASH CYCLE:
When the washing cycle has finished, the buzzer of the dishwasher will
sound for 8 seconds, then stop.
1. Turn off the appliance using the ON/OFF button, shut off the
water supply and open the door of the dishwasher.
2. Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better.
3. Unplug the dishwasher.

CLEANING AND CARE

Cleaning the Filter Assembly:
The filter prevents larger remnants of food or other objects from getting
inside the pump. The filtering system consists of a coarse filter, a flat
(main) filter and a fine filter.
TIP: For best performance and results, the filter assembly must be cleaned
regularly. Remove the larger particles trapped in the filter after each
wash cycle.
WARNING:
NEVER RUN THE DISHWASHER WITHOUT THE FILTERS IN PLACE.
IMPROPER REPLACEMENT OF THE FILTERS MAY REDUCE THE
PERFORMANCE LEVEL OF THE APPLIANCE AND DAMAGE DISHES
AND UTENSILS.
By unscrewing the coarse filter, you can remove the filter system.
Remove any food remnants and clean the filters under running water.
Use a brush to gently clean the filters, if necessary.
Ginnys.com • 1.800.544.1590
1. Main filter
2. Fine filter
3. Coarse filter
13