NoBark 6 Operating Guide Please read this entire guide before beginning...
Page 2
To Insert and Remove the Battery ........5 To Test the NoBark 6 ............7 To Fit the NoBark 6 ............8 Regular Maintenance ............9 What to Expect During Use of the NoBark 6 ....10 Accessories ..............11 Frequently Asked Questions ..........12 Troubleshooting ...............14 Service ................15...
Vibration Sensor Probe, a Static Correction is administered through the Contact Points. The NoBark 6 starts with the lowest level of Correction and then increases through 6 levels each time your dog barks within 30 seconds of the previous bark. If your dog does not bark again within 30 seconds, the NoBark 6 will reset itself to the lowest level of Correction.
Important: • DO NOT use the NoBark 6 with any additional collars, tags, leashes or other items that may cause vibration and trigger a false correction. • Your dog may wear a harness for attaching a leash and/or tags while using the NoBark 6.
To Insert and Remove the Battery Note: Do not install the battery while the NoBark 6 is on your dog. This NoBark 6 utilizes a replaceable RFA-67 battery. This unique battery is designed to make battery replacement easier and increase water protection.
Page 6
Note: After battery removal, the NoBark 6 may activate 2 or 3 additional times. To ensure the NoBark 6 is deactivated, slide the Vibration Sensor Probe across a table or hard surface several times, until the NoBark 6 stops beeping.
To Test the NoBark 6 Slide the Vibration Sensor Probe across a rough surface for at least 10 inches. The NoBark 6 should beep. If your NoBark 6 doesn’t beep during this test, see “The NoBark 6 does not beep” in the “Troubleshooting”...
Note: It is sometimes necessary to trim the hair around the Contact Points to make sure that contact is consistent. 4. Check the tightness of the NoBark 6 by inserting one fi nger between the end of a Contact Point and your dog’s neck.
• Check your dog’s neck for irritation (daily). • Check fi t of NoBark 6 on dog (daily). • Check Battery for proper fi t in NoBark 6 (weekly). • Check Contact Points for tightness, fi nger tight plus turn with pliers (weekly).
fi rst time they wear the NoBark 6. You should notice a reduction in your dog’s barking within the fi rst couple of days that he wears the NoBark 6. At this point, it is important to remember the learning process is still not complete.
Accessories To purchase additional accessories for your SportDOG NoBark 6, contact the Customer Care Center at 1-800-732-0144 or visit our website at www.sportdog.com to locate a retailer near you. Component Part Number Battery - two pack RFA-67D-11 Replacement Collar RFA-68...
Will another dog’s • No. bark set off the NoBark 6? Is the NoBark 6 safe • Yes. The NoBark 6 is designed to and humane? get your dog’s attention, not to punish him. However, the initial Correction may startle your dog.
Page 13
Is it possible for my • Yes. This is best accomplished by dog to learn not to placing the NoBark 6 on your bark only when the dog only in situations where you NoBark 6 is on? never want him to bark, and...
Troubleshooting The NoBark 6 does • Test the NoBark 6 (see “To Test not beep. the NoBark 6” section). • If your NoBark 6 does not beep during this test, try the same test on a rougher surface. • Ensure that the battery is properly installed.
Center at 1-800-732-0144 for help in troubleshooting and, if necessary, to arrange a repair for your product (a service charge may apply). Also, please visit our website at www.sportdog.com for more Frequently Asked Questions and Troubleshooting Tips. _______________________________________ Terms of Use and Limitation of Liability 1.
Need help?
Do you have a question about the NoBark 6 and is the answer not in the manual?
Questions and answers