Advertisement
14
Inserting a CD
1. Press the Load/Eject button. The CD tray will be ejected.
2. Place the disc in the center of the tray with the label side facing up.
3. Press the Load/Eject button. The CD tray will be retracted.
Removing a CD
1. Press the Load/Eject button. The CD tray will be ejected.
2. Remove the disc.
3. Press the Load/Eject button. The CD tray will be retracted.
WARNING:
Do not forcibly push the CD tray in by hand. Doing so may result in damage.
Note:
If an eject prohibit command has been received from the computer, the
CD tray will not be ejected even if the Load/Eject button is pressed.
Emergency Eject
The procedure described below can be used to remove a disc from the
CD-ROM reader if the Load/Eject button is disabled by software or a
power failure occurs.
1. Turn off the power to the computer installed the CD-ROM reader.
2. Insert a steel rod (about 1.3mm in diameter) into the emergency eject
ECDR3001.PM5
hole and push hard. The CD tray is ejected by about 10mm. Pull it all
the way open by hand.
A stiff paper clip may be used as a steel rod.
15
65mm
(AT LEAST 45mm IN LENGTH)
99.1.13, 2:37 PM
Advertisement
