Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
WEAK OR DEAD
BATTERY
REPLACING BATTERY (See Fig. 43)
WARNING: Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc. Positive terminal
must be connected first to prevent
sparking from accidental grounding.
•
Lift hood to raised position.
•
Remove terminal cover.
•
Disconnect BLACK battery cable then RED battery
cable and carefully remove battery from tractor.
•
Install new battery with terminals in same position as
old battery.
•
Reinstall terminal cover.
• First connect RED battery cable to positive (+) battery
terminal with bolt and nut as shown. Tighten securely.
•
Connect BLACK grounding cable to negative (-) battery
terminal with remaining bolt and nut. Tighten securely
•
Close hood.
TERMINAL
COVER
POSITIVE
(RED)
CABLE
TO REPLACE HEADLIGHT BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill.
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
•
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring.
FULLY CHARGED
BATTERY
Fig. 42
NEGATIVE
(BLACK)
CABLE
Fig. 43
02954
TO REPLACE FUSE (See Fig. 44)
Unit has two automotive type fuses. Replace primary
operation fuse with a 20 amp and the differential lock
actuator fuse with a 10 amp. The fuse holders are located
behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 45)
•
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
07002
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and
adjustment should not be necessary. If adjustment is nec-
essary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and adjust-
ment should not be necessary. If adjustment is necessary,
see engine manual.
TRANSMISSION
REMOVAL/REPLACEMENT
Should your transmission require removal for service or
replacement, it should be purged after reinstallation and
before operating the tractor. See "PURGE TRANSMISSION"
in the Operation section of this manual.
26
Fig. 44
HOOD
HEADLIGHT WIRE
CONNECTOR
Fig. 45
Hide quick links:
Advertisement
Table of Contents
