Monnit MonnitLink CGW2 User Manual page 15

Warning: &KDQJHV RU PRGL¿FDWLRQV QRW H[SUHVVO\ DSSURYHG E\ 0RQQLW FRXOG YRLG
WKH XVHU¶V DXWKRULW\ WR RSHUDWH WKH HTXLSPHQW
RF Exposure
WARNING:
WUDQVPLWWLQJ GHYLFHV WKH DQWHQQD XVHG IRU WKLV WUDQVPLWWHU PXVW QRW EH
FRORFDWHG LQ FRQMXQFWLRQ ZLWK DQ\ RWKHU DQWHQQD RU WUDQVPLWWHU
FCC ID: ZTL-RFSC1
This device has been designed to operate with an approved antenna listed below, and
KDYLQJ D PD[LPXP JDLQ RI  G%L $QWHQQDV QRW LQFOXGHG LQ WKLV OLVW RU KDYLQJ D JDLQ
greater than 5.1 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that
required for successful communication.
Approved Antennas
7KH IROORZLQJ DQWHQQDV DUH DSSURYHG IRU XVH ZLWK )&& ,' =7/5)6&
‡ +\SHUOLQN +* 5'563  G%L 5XEEHU 'XFN
‡ 3XOVH :  G%L 5XEEHU 'XFN
‡ &KDQJ+RQJ *60  G%L 5XEEHU 'XFN
‡ 6SHFLDOL]HG 0DQXIDFWXULQJ 0&$17& ´ ZKLS
FCC ID: MIVCNN0301
This device complies with the RF requirements applicable to broadband PCS equipment
RSHUDWLQJ XQGHU WKH DXWKRULW\ RI  &)5 3DUW  6XESDUW ( DQG 3DUW  RI WKH )&& 5XOHV
DQG 5HJXODWLRQV 7KLV FHUWL¿FDWLRQ LV FRQWLQJHQW XSRQ LQVWDOODWLRQ RSHUDWLRQ DQG XVH RI WKH
(QDEOHU +6  PRGXOH DQG LWV KRVW SURGXFW LQ DFFRUGDQFH ZLWK DOO LQVWUXFWLRQV SURYLGHG
WR ERWK WKH 2(0 DQG HQG XVHU :KHQ LQVWDOOHG DQG RSHUDWHG LQ D PDQQHU FRQVLVWHQW ZLWK
WKH LQVWUXFWLRQV SURYLGHG WKH (QDEOHU +6  PRGXOH PHHWV WKH PD[LPXP SHUPLVVLEOH
H[SRVXUH 03( OLPLWV IRU JHQHUDO SRSXODWLRQ  XQFRQWUROOHG H[SRVXUH DW GH¿QHG LQ 6HFWLRQ
 RI WKH )&& 5XOHV DQG 5HJXODWLRQV
7KH (QDEOHU +6  PRGXOH LV GHVLJQHG IRU XVH LQ D YDULHW\ RI KRVW XQLWV ³HQDEOLQJ´ WKH
host platform to perform wireless data communications. However, there are certain criteria
relative to integrating the modem into a host platform such as a PC, laptop, handheld,
monitor and control unit, etc. that must be considered to ensure continued compliance with
FCC compliance requirements.
,Q RUGHU WR XVH WKH (QDEOHU +6  PRGXOH ZLWKRXW DQ\ DGGLWLRQDO )&& FHUWL¿FDWLRQ WKH
installation must meet the following conditions:
‡ 7KH V\VWHP DQWHQQD V FRQQHFWHG WR WKH (QDEOHU +6  PRGXOH PXVW EH LQVWDOOHG WR
provide at least 20cm separation from the human body during normal operation.
‡ 7KH V\VWHP DQWHQQD V XVHG ZLWK WKH (QDEOHU +6  PRGXOH PXVW QRW H[FHHG WKH
following levels:
‡ Band Class 0: the maximum gain is 2.2dBi.
‡ Band Class 1: the maximum gain is 8dBi.
If any of these conditions are not met then additional information should be sought from the
)&& RU DQ )&& TXDOL¿HG WHVW ODERUDWRU\
7R VDWLVI\ )&& 5) H[SRVXUH UHTXLUHPHQWV IRU PRELOH
3$*(