Monnit Serial MODBUS Quick Start Manual

Monnit Wireless Sensors
Serial MODBUS
(RTU/ASCII) Gateway

Quick Start Guide

Information to Users
his equipment has been tested and found to comply with the limits for a Class B digital
T
devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of more of the following measures:
‡ Reorient or relocate the receiving antenna
‡ Increase the separation between the equipment and receiver
‡ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
‡ Consult the dealer or an experienced radio/TV technician for help.
WARNING: &KDQJHV RU PRGL¿FDWLRQV QRW H[SUHVVO\ DSSURYHG E\ 0RQQLW FRXOG YRLG WKH XVHU¶V
authority to operate the equipment.
RF EXPOSURE WARNING:
ting devices, a separation distance of 20 cm or more should be maintained between the
antenna of this device and persons during device operation. To ensure compliance, opera-
tions at closer than this distance are not recommended. The antenna used for this transmit-
ter must not be co-located in conjunction with any other antenna or transmitter.
Inside the Box
<RX VKRXOG ¿QG WKH IROORZLQJ LWHPV LQ WKH ER[
‡ 0RQQLW 6HULDO 02'%86 *DWHZD\
‡ $QWHQQD
‡ 0RQQLW :LUHOHVV 6HQVRUV
‡ %DWWHULHV
‡ 0RXQWLQJ +DUGZDUH
‡ 8VHUV *XLGH
To satisfy FCC RF exposure requirements for mobile transmit-