Functions Of The Buttons - Sony trinitron PVM-1450QM Service Manual

Operating through menus
There are five buttons for menu operations on the front of
the monitor. To display the main menu, first press MENU.
The buttons you can use appear at the bottom of the menu
screen.
Functions of
the
buttons
Button To select menu To adjust menu item
Item selected
MENU
return to the return to the previous
lli:HII
previous menu menu
ENTER
decide a selected select an item
E:~!!!:11
item
t
move the cursor increase selected value
-
(..,.) upwards
•
move the cursor
decrease selected
value
(..,.) downwards
ldi1il
reset current adjustment
value to the factory
setting
(The above items in white type correspond to the marks in
the menu.)
front of monitor
RESET
button
[IJ
Main menu
buttons for
menu
operations
Select an item and press ENTER to go to the following
menu.
[g)
CHROMA SET UP menu
Set to ON to adjust the internal decoder for CHROMA
and PHASE after AUTO ADJUST([§]). IOFFI
@]
USER CONFIG 1 menu
Select an item to adjust. To go to the USER CONFIG 2
menu select NEXT PAGE.
-9-
@]
USER CONFIG 2 menu
Select an item to adjust. To go to the USER CONFIG 1
menu select PREVIOUS PAGE.
[§]
AUTO ADJUST screen
Select the color bar signal (full, SMPTE, EIA) and press
ENTER to start auto adjusting for CHROMA SET UP
(NTSC signal only).
[ID
COLOR SYSTEM DISPLAY menu
Select the color system display mode. In AUTO, the kind
of color system being used appears on the screen each
time you change the signal input. [AUTO[
II]
V HOLD screen
Adjust the vertical hold if the picture rolls vertically.
When you cannot read the display, select the input that
is not connected .
[ill
RGB SYNC menu
Select SYNC ON G to operate the monitor on the sync
signal from the displayed green signal.
Select EXT SYNC to operate the monitor on an external
sync signal fed through the RGB SYNC connector.
[SYNC ON Gl
[ID
NTSC SETUP LEVEL menu
Select the NTSC setup level from two modes. The 7.5
setup level is mainly used in north America. The O setup
level
is mainly used in Japan.
IOI
[Q]
LANGUAGE menu
You can select the menu language from among the
five
languages (English, German, French, Italian, Spanish) on
the menu.
I
ENGLISH
I
([ ] indicates the factory setting position.)
5